BOOT REPAIR SERVICES

Resole and Heel

The removal and replacement of the outer soles and heels. Including the shank, cork-filler and welt strip.

Replace Heel Stack

The heel stack is the stack of leather above the heel rubber that makes up the heel. Where the heel stack is worn or damaged, the complete heel stack requires replacing.

Replace Heel Rubber

The heel rubber can be replaced individually, without the additional cost of replacing the complete heel, where there is no damage to the heel stack.

Replace Elastics

Due to age and/or wear and tear, the elasticity in the elastics may diminish and the elastics will require replacing. These can be replaced individually or all four at the same time.

Replace Tugs

Our boot tugs should remain in your boots for the life of your boots however they can be replaced if they become worn or damaged. They can be replaced individually or all four at the same time.

IN-STORE SERVICES

Some services are only available in-store or from a licensed repairer as the boot needs to be physically examined.

Relast

The re-manufacture of the boot - only the upper leather, lining, tugs and elastics remain (all other components are replaced). The removal and replacement of the outer soles and heels (including the shank, cork-filler and welt strip) AND the innersole.

Innersoles are a very important component in footwear and should be in a reasonable condition at all times. A re-last is required for a number of reasons but the most common reason is the poor condition of the innersoles. Moisture, heat or age can cause the innersoles to deteriorate and no longer be able to perform.

In order to perform a re-last, the boot linings need to be in a reasonable condition. Where the linings are worn or contain holes etc, they will also require replacing, resulting in a Re-last and Lining repair.

Re-last and Lining

The re-manufacture of the boot - only the upper leather, tugs and elastics remain (all other components are replaced, including the linings). A relast is required in order to replace linings, therefore a Re-last and Lining repair is required for worn or torn linings.

Altering the Boot Size or Fitting

A relast is required in order to alter the boot size or fitting. Only footwear manufactured with a screwed or welt sole can be altered. The following alterations can be made.

• Size Increase – ½ size only
• Size Decrease – a maximum of 1 full size only

• Width Increase – a maximum of one width only
• Width Decrease – a maximum of 2 widths only

Note: A width increase is only possible when the toe shape does not change.

Changing Sole Types

The following changes can be made to the sole of the boot during a re-sole and heel or a re-last.

• A plain leather welt can be changed to plain rubber welt (and vice versa) 
• A comfort leather welt can be changed to comfort rubber welt (and vice versa) 

Note: Dynamic Flex and Screwed soles cannot be changed. 

Note: Plain innersoles cannot be replaced with comfort innersoles (and vice versa) 

Changing Heel types

The following changes can be made to the heel of the boot during a re-sole and heel or a relast.
• A block heel can be changed to a cuban heel (and vice versa) 
• A flat heel can be changed to a ladies tapered flat heel (and vice versa)

Note: High heels cannot be changed to flat heels (and vice versa).